My Account  |  0 item(s)    View Cart
CMC PT-130 Tilt and Trim for up to 130 HP
CMC PT-130 Tilt and Trim for up to 130 HP

CMC PT-130 Tilt and Trim 13001 WITH Gauge 13001

Your Price: $899.00
Retail Price:$1,232.04
Your Savings:$333.04(27%)
Part Number:13001

Choose Options

Spacer for Pontoon Boat
Transom Spacer for Pontoon Boat (#13032) [+$49.00]
Clamp Motor Adapter
Transom Clamp Motor Adapter (#13022) [+$79.00]
Electric Hydraulic Tilt & Trim

CMC PT-130 Tilt and Trim 13001 WITH Gauge 13001

You Get Power Tilt & Trim, Better Boat Handling, More Speed, Lower Fuel Consumption and No More Back Strain!

The CMC PT-130 Tilt & Trim incorporates a 6" setback which enhances Boat Stability and enables the prop to get a better "bite" at a higher prop setting. With the touch of a switch you can raise your motor to protect your prop from damage and your back from strain. The PT130 Tilt & Trim has 20 degrees of trim and 90 degrees of trim and tilt. It allows to tuck your motor in to get your boat on plane smoother and faster. 

When you're underway, you can change the angle of your motor to obtain the best performance for your load and water conditions. It gives you a more stable ride, increases top end speed, allows more prop clearance, and better fuel economy.

  • Rated for 130 H.P. and Smaller Motors.
  • 6" Set Back to Enhance Boat Stability and Performance.
  • 20° of Trim and a Total of 90° of Tilt and Trim.
  • 1/2" 6061 T6 Extruded Aluminum Construction with Stainless Steel Fasteners.
  • Electric Hydraulic Actuator Rated at 7853 lbs. of Thrust!
  • Standard B.I.A. Bolt Hole Pattern.
  • Convenient Adapter Kit Available for Clamp-on Motors.
  • Four Stainless Steel Motor Mounting Bolts Included.
The CMC PT-130 has been predrilled to fit standard B.l.A. outboard motor mounting hole configurations. If your boat and motor is not drilled to these specifications, some drilling may be necessary. Consult an installation manual for your outboard for proper mounting dimensions. Be sure to use at least l/2” diameter stainless steel bolts and nuts for mounting the PT-130 to boat. A convenient adapter kit is available at CMC for mounting smaller motors to the PT-130 that are mounted with transom clamps.

The Electric Hydraulic System is totally waterproof and is rated over 7800 lbs. of thrust! This system is made of 100% nonferrous material which makes it more impervious to saltwater and freshwater

The CMC Power Tilt and Trims are made of 6061 T6 alloy aluminum extrusions and fastened with stainless steel fasteners for maximum strength and durability.No welds or castings (molded aluminum) to break. CMC is the only manufacturer offering a 5-year structure warranty

This unit, the PT-130 13001, includes the tilt and trim gauge which is sealed and drip proof and mounts in the dash of the boat for safe and convenient height determination.The sending unit is completely sealed and waterproof, which eliminates any moisture problems.The up-down toggle switch is standard equipment.

Related Items


Recently Viewed Items