|
For outboard owners without factory tilt and
trim, Bob's Machine Shop has a solution.
Designed for motors up to 40 hp, BMS's new
hydraulic Tilt & Trim can provide increased
performance, better handling and less hassle
raising and lowering the motor at the launch
ramp.
The Tilt & Trim allows skippers to trim the boat for a
smoother, drier ride. When fully trimmed in, it provides a
negative 3-degree tuck-under angle for faster starts and
quicker on-plane times. After reaching plane, the boat can
be optimized for best running angle by trimming the tilt up
to its maximum of 75 degrees. A 5-1/2 inch setback is
standard.
The hydraulically operated Bobs Machine Shop Tilt &
Trim weighs only 14 pounds and will accommodate clamp-on
motors, not standard BIA bolt pattern style. Call for
questions.
The hydraulic pump is mounted inside the boat for protection
against the elements.
The Over all
mounting dimensions, which are: 11.5" wide by 10" length
BMS's Tilt & Trim is easy to install. It comes with
hydraulic pump, wiring harness, control switch, hoses, oil
and carries a limited lifetime structural warranty. The pump
comes with a 3-year warranty.
|
