CMC PL-65 Set Back Plates 40012, 55012, 70012, 90012, 50012 Vertical Extension Cook Mfg

The two piece adjustable manual has 5" of slot adjustment at the motor mounting bracket and 1-1/2" of adjustment at the transom bracket. After height adjustment has been made, tighten the four bolts on the sides to 100 foot pounds to hold the position in place. Available in 5-1/2 or 4 inch set-back.

The 7 inch static set-back plate has 1-1/2" of adjustment at the transom bracket and 1" of adjustment on the motor bracket. It is available with 4 degrees of positive or negative trim. It also can be purchased with no trim angle. (70012)

The 9 inch static set-back plate also has 1-1/2 inches of adjustment at the transom and one inch of adjustment on the motor bracket. (90012)

The 5 inch vertical extension allows the motor to be mounted 5 inches higher than the standard mounting on the transom. It is a must for conversion from a prop to jet drive. Another application includes mounting the 5" vertical extension on the hydraulic Power-Lift to raise the motor higher on shallow running boats that are equipped with tunnel extensions. (50012)